Brief on TPH260 Extruder

The whole TPH260 extruder can be divided into 4 parts: a feeder, a conditioner and a principal machine and a cutting cart. Corresponding safety marks are pasted on the required surface positions of these 4 parts, for detail see Fig.1.11～Fig.1.13. Each arrow directions in the figures point to the pasting positions and the numbers in the circle represent the contents in Table 1-2.

For example: In Fig 1-11, the position with mark "8" needs to paste the safety marks with No. "8" in the table 1-2, in other words, this position needs to paste the code "COMM65010005", and the safety mark named "clockwise direction".

In normal production of the extruder, the pressure in the extruding chamber is high; therefore the installation manner of the extruding machine has reached all the requirements of firm connection of the extruding chamber in theoretical calculation and practical application. However, the accidents have occurred such as "jetting out" of the extruding chamber or discharging device in the production due to improper installation, screw fatigue and so on. Therefore, it is required that no anyone stands at front of extruding chamber when the extruder is running.

If any accidents are caused due to not obeying the stipulations in the Operation Manual and the control system for Muyang machinery equipment is not used as per the conditions mentioned above, the Muyang will refuse to take any responsibility. If the Muyang is required to take responsibility, it will reserve the right to investigate and affix the responsibility of the operator.